SATO WS412DT - Sensor Calibration and Testing

3
System
Mode
Self
-
Test
and
Dump
mode
WS4-DT-r01-30-12-16TM
40
3.3.2 Dump Mode
Your printer enters Dump mode after running a self-test. In this mode, characters
are printed in hexadecimal codes, allowing users and engineers to debug the
system.
To return to the online mode:
■
Turn off your printer and turn it on again.
■
In SATO WS4 Printer Utility, in the Navigation pane, click Tool. In the
Properties pane, click Reboot Printer and click Send.
This is applicable for SZPL, SDPL and SEPL.