SATO WS412DT - Page 71

6 SATO WS4 Printer Utility Work with SATO WS4 Printer Utility
60
Property Name
Description
Inch Change the unit of Position Adjustment to inch.
dots Change the unit of Position Adjustment to dots.
Horizontal Offset
Move the print position horizontally. The positive number
is left, and the negative number is right.
Vertical Offset
Move the print position vertically. The positive number is
forward, and the negative number is backward.
Continuous Offset
Adjust the continuous offset at which the continues label is
cut.
Tear Off Offset
Adjust the rest position of the media after a label is
printed, which changes the position at which the label is
torn or cut.
Cutter/Dispenser
Offset
Adjust the cutter/dispenser offset position at which the
label is peel or cut.
Status
This is communication protocol for SBPL. Status 3 is Enq
response and Status 4 is for the communication via driver.
STX Code When you use non-standard code, you can set the code in
this section.
ETX Code When you use non-standard code, you can set the code in
this section.
ESC Code
When you use non-standard code, you can set the code in
this section.
ENQ Code
When you use non-standard code, you can set the code in
this section.
CAN Code When you use non-standard code, you can set the code in
this section.
NULL Code When you use non-standard code, you can set the code in
this section.
Offline Code When you use non-standard code, you can set the code in
this section.