The print head is hot after printing. Be careful not to get
burned when replacing media or cleaning immediately
after printing.
Touching the edge of the print head with bare hands could
result in injury. Be careful not to become injured when
replacing media or cleaning.
The customer should not replace the print head. Doing so
could result in injury, burns or electric shock.
Do not place in areas with high humidity
Do not place the printer in areas with high humidity or
where condensation forms. If condensation forms,
immediately turn off the power switch and do not use the
printer until it dries. Using the printer while condensation
is on it could result in electric shock.
When moving the printer, always unplug the power cord
from the outlet and check to make sure all external wires
are disconnected before moving it. Moving the printer
with the wires still connected could damage the cords or
connecting wires and result in a fire or electrical shock.
Do not carry the printer with media loaded in it. The media
could fall out and cause an injury.
When setting the printer on the floor or a stand, make sure
not to get your fingers or hands pinched under the printer
feet.
Do not operate the power switch or plug in/ unplug the
power cord with wet hands. Doing so could result in
electric shock.
Keep the power cord away from hot devices. Getting the
power cord close to hot devices could cause the cord’s
covering to melt and cause a fire or electric shock.
When unplugging the power cord from the outlet, be sure
to hold it by the plug. Pulling it by the cord could expose or
To Next Page
Loading...
