SawStop RT-TGP - In-Line Right: Between 36 Rails Configuration (PCS ONLY); In-Line Right: Between 52 Rails Configuration (PCS ONLY)

4
RT-TGP/RT-BT OWNER’S MANUAL
In-Line Right: Between 52” Rails (PCS ONLY)
In-Line Right: Between 36” Rails (PCS ONLY)
Option 4 of 4
Option 3 of 4
This conguration is installed in place of the extension table, and reduces the total
footprint of your SawStop table saw and router table assembly while maintaining the
most ripping capacity to the right of the saw blade. The 36” extension table (sold
separately) can be installed to ll the gap between the right cast iron wing and the
router table.
Shown:
• 27” x 16” Cast Iron Router Table (RT-C27)
• Support Legs (RT-ST2)
• Power Switch (RT-PSW)
• 36” Extension Table (TGP2-T36A) - sold separately
This conguration is installed in place of the extension table, and minimizes the total
footprint of your SawStop table saw and router table assembly. An intermediate cast iron
wing (sold separately) can be installed to ll the gap between the right cast iron wing and
the router table.
Shown:
• 27” x 16” Cast Iron Router Table (RT-C27)
• Support Legs (RT-ST2)
• Power Switch (RT-PSW)
• Intermediate Cast Iron Wing (RT-ICW) - sold
separately