Name: SCADAmetrics EtherMeter
Brand: SCADAmetrics
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Analog

Input 2

4-20mA (default) or 0-5VDC.

0-5VDC is activated by removing JP2 (inside case).

4-20mA loop resistance = 240 Ohms.

AIN2- is connected to DC Common (GND).

Caution: AIN2+ should NEVER be connected to a voltage greater than 5VDC

above the DC common.

(See Recommended Wiring Diagram later in this section.)

Non-Isolated, Fused.

If isolation is desired, an external analog-to-analog isolation module may be

used. (eg. Dataforth Sensorlex

8B series or DSCA series modules.)

Questions and Answers:

Need help?

Do you have a question about the SCADAmetrics EtherMeter and is the answer not in the manual?

SCADAmetrics EtherMeter Specifications

General