Scaime eNod4-C - Page 53

53
SCAIME Manual : NU-eNod4C-E-0418-196712-F.docx
12.1.5.2 starting parameters
Parameter
Possible value
Description
eNod number
1-6
Number of eNod4 supported
Starting eNod
[Yes], [No]
Enable/Disable the function to start on main screen of a specific
eNod
1 – eNod Number
Number of starting eNod4.
If there is only one eNod4 supported this function is necessarily
activate.
12.1.5.3 Calibration setup
When using eNod4 for legal for trade purpose, it is
imperatively required to activate the legal for trade switch
BEFORE any calibration procedure (cf § legal for trade switch).
!