Need help?Do you have a question about the Scaime eNod4-B and is the answer not in the manual?
General| Brand | Scaime |
|---|---|
| Model | eNod4-B |
| Category | Transmitter |
| Language | English |
Details on accessible communication protocols like Modbus RTU and SCMBus via AUX, USB, and DB9.
Describes the physical interfaces (USB, DB9, AUX) for Modbus RTU communication and baud rates.
Details physical interfaces for SCMBus/Fast SCMBus communication (USB, AUX ports) and supported baud rates.
Describes the CAN 2.0A compatible interface supporting CANopen® protocol and supported baud rates.
Describes eNod4 as an NMT slave and its four NMT states (Initialization, Pre-operational, Operational, Stopped).
Covers Heartbeat, Boot-up, and Node guarding mechanisms for controlling node states on the bus.
Explains the object dictionary (OD) and its importance in CANopen® devices for accessing data.
Focuses on PDO communication objects, specifically RPDO default mapping parameters.
Describes the physical connection via SUBD 9-pin connector and supported baud rates for Profibus DPV1.
Lists Profibus DP features like Sync, Freeze, Fail-safe, and diagnosis frames.
Explains how eNod4 transmits measurements through various protocols and lists accessible variables.
Details the weighing diagnosis system for checking analog sensor input integrity and overall measurement chain.
Provides a comprehensive list of functional commands and their corresponding command codes.
Details various functional commands like Reset, EEPROM storage, Tare, Zero, and Calibration procedures.
Describes two calibration methods: Theoretical and Physical calibration.
Details settings for calibration, including maximum capacity, segments, loads, and sensor sensitivity.
Describes filter settings like A/D conversion rate, activation, cutoff frequencies, and filter depth.
Details settings for logical inputs and outputs, including assignment, holding time, and set points.
Discusses legal for trade options and indicators for weighing applications and metrological requirements.
Details settings related to legal for trade, including switch, version, counter, checksum, and zero functions.
To Next Page
