Scaime eNod4-B - Measurement Transmission; EEPROM Error Management

15/95
User manual SCAIME: NU-soft-eNod4B-E-0716_236704-C.doc
Address Modbus RTU
Meaning
Access
Type
0x0000
SW and product version
RO
Uint
The 12 LSB bits define the software version (073
H
= 115) and the 4 MSB bits define the product version (6
H
for the
eNod4).
3.7 Measurement transmission
As a master/slave protocol, measurement transmission in Modbus protocol is only done on master request.
3.8 EEPROM error management
Functioning and calibration parameters are stored in EEPROM. After every reset the entireness of parameters stored
in EEPROM is checked. If a default appears, measurements are set to 0xFFFF and default is pointed out in
measurement status.