THIRD DISPLAY (€)
The amount is shown in this display.
FUNCTION OF THE SYMBOLS
The LCD displays have symbols which show the indicator’s functioning status; you will find the description for each symbol
below.
6. OPERATION
6.1 AUTOMATIC ZERO UPON START-UP
The indicator has an “auto zero at start-up” function: in other words it means that if at start-up a weight within the
configured percentage (see F6 step, section 7)
of the capacity is detected, it will be zeroed; if the weight is not within
this tolerance, the display shows “Err 4” and with a non approved instrument the present weight after a few instants,
while with an approved instrument “Err 4” is shown continuously.
6.2 ZEROING THE SCALE
When there is no item on the scale but reading is not zero, press the ZERO key to turn on ZERO indicator. If the
weight is greater than the programmed percentage (see F7 step, section 7)
in respect to the capacity, the zeroing will
have no effect.
6.3 TARE FUNCTION
Put container on the platter, once the weight reading is stable, press the TARE key, the TARE indicator will be on and
the container’s weight will be deducted. When it is time to clear the TARE, take off the container, and press TARE key
again.
6.3.1 LIMITATION OF THE TARE FUNCTIONS
It is possible to limit the tare functions, selecting "oFF" in the F8 step of the set-up environment (see section 7)
The SEMI AUTOMATIC TARE could be made only if the tare is equal to 0.
NOTE: With approved instrument, the F8 step is not settable.
6.4 OVERLOAD WARNING
Please do not add item that is over the maximum capacity. When reading “—OL—“ and hear beeping sound,
remove the item on the platter to avoid damage to the load cell.
6.5 CHANGE PRICE UNIT
You can use the UNIT key to change unit. Press UNIT key will change the weighing unit circularly, and the pertinent
indicator will on.
NOTE: at start-up the scale suggests automatically the main price unit setted in the set-up (see F2 step, section 7)
6.6 UNIT PRICE SETTING
To trade with your scale, it is necessary to setting a unit price of the goods, the scale then uses this unit price to
determine how much that goods are on the platter. When the scale is displaying the weight of the goods placed on the
scale, set the unit price through numeric keys. Set unit price is showed in the second display, the third display shows
The instrument is in the first weighing range.
The instrument is in the second weighing range.
The displayed weight is a net weight.
The weight detected by the weighing system is near
1/4 ÷ +1/4 of the division.
Indicates the price unit in use
Indicates the price unit in use
The automatic unit price clear is disabled
The total amount is greater than 0.
To Next Page
Loading...
