12
Remove the oil filler plug filler the oil to the gear box until the oil lever reach the middle of oil
fluid lever indicator. Then look the plug.
Lubrication:
All ball bearings in your mill/drill are sealed for life, requiring no lubrication. Points requiring
lubrication are:
• Internal spindle drive assembly. Keep this area well lubricated with a good grade non-
hardening grease. Insert grease in the hole at the top of spindle pulley spindle driver.
Lube twice yearly.
• A tight film of oil applied to the quill and column will reduce wear, prevent rust and assure
ease of operation.
• Quill return spring should receive oil (SAE 20) once yearly. Remove cover plate and
apply oil with squirt can or small brush.
• Important: The gear box should be oiled with as lubricant such as SAE 68 oil in level.
Change oil every one year
• Apply Lubricate to quill pinion every 90 days.
NOTE. Use extreme care when performing this operation and keep hands clear of
pinch points. When using paraffin bar, do this only by turning the sheaves by hand.
Do not apply with motor running.
Trouble Shooting
• No running after switch on:
1. Main interruption while volts irregular - Adjust input voltage and draw back the
main switch.
2. Break down of fuse in switch box - Replace with new one.
3. In case of too must current, the overload relay jumps away automatically – Press
the overload relay, and it will return to the correct position.
• Motor Overheat and No Power:
1. Overload - Decrease the load of feed.
2. Lower voltage - Adjust to accurate voltage.
3. Spoiled contact point of magnetic switch - Replace with new one.
4. Breakdown of overload relay - Connect it or replace with new one.
5. Motor is poor - Replace with new one.
6. Break down of fuse or poor contact with wire (it is easily, to spoil motor while short
circuit) Switch off power source at once and replace fuse with new one.
7. If the machine is with tapping attachment, there is an aid plum screw fix on the
motor mount in order to avoid the motor pulleys shake while turning.
• The temperature of spindle bearing is too hot:
1. Grease is insufficient - Fill the grease.
2. The spindle beating is fixed too tight - turning with no speed and feel the tightness
with hand.
3. Turning with high speed for a long time - Turn it to lightly cutting.
• Lack of power with main spindle revolving:
1. Motor has burned out - Change a new motor.
2. Fuse has burned out - Replace with new one.
• Table travel has not balanced:
1. The gap of spindle taper too wide - Adjust bolt in proper.
2. Loosening of leaf bolt - Turn and fasten in place.
To Next Page
Loading...
