7
4. Delivery and Installation
1. Be sure all locks of headstock and column are tightened before operation.
2. Always keep proper footing and balance while moving this 300 kgs. machine and only
use heavy duty fibre belt to lift the machine.
3. Keep machine always out from sun, dust, wet, and raining area.
4. Properly position and tighten 4 bolts into base holes after machine is in balance.
5. Turn off the power before wiring and be sure the machine is in proper grounding.
Overload and circuit breaker is recommended for safety wiring.
6. Check carefully that main shaft runs in clockwise direction. If this is not the case it is
necessary to change 2 phases - then repeat the test till spindle direction is correct.
7. Finish removing this wooden case/crate from the machine. Unbolt the machine from
the crate bottom.
8. Carefully lift the machine to a sturdy stand or work bench. For best performance,
through bolt the machine to bench stand.
9. Bolt the stand legs to the floor, while using a sturdy stand.
5. Operating the machine
Use of Main Machine Parts
1. To raise and lower the head by head handle.
2. Equipped with an electric switch for tapping operation clockwise or counter clockwise.
3. To adjust the quick or slow feeding by feed handle.
4. To adjust the table left and right travel by table handle wheel.
5. To adjust the table fore and aft travel by table handle wheel.
6. To operate the spindle handle wheel for micro feed.
7. To adjust the scale size according to working need.
Precaution for operation
Check all parts for proper condition before operation; if normal safety precautions are
noticed carefully, this machine can provide you withstanding of accurate service.
1. Before Operation
a) Fill the lubricant.
b) In order to keep the accurate precision, the table must be free from dust and oil
deposits.
c) Check to see that the tools are correctly set and the work piece is set firmly.
d) Be sure the speed is not set too fast.
e) Be sure everything is ready before use.
2. After Operation
a) Turn off the electric switch.
b) Turn down the tools.
To Next Page
Loading...
