19
RETURN TO TABLE
OF CONTENTS
Power On Switch
• When one of the Foot Control function pedals is depressed, the floor locks
will engage before allowing a function to begin. After the table has been
locked to the floor you can activate a function by pressing on its pedal.
Disable
• Pressing
DISABLE
on the hand control or emergency
override panel will stop a function that is being controlled
by the Foot Control. To continue a function you must
remove pressure from the foot switch pedal; then press
down on the pedal again.
Table Positioning
• Six positions can be activated using the Foot Control, Trendelendburg,
Reverse Trendelenburg, Lateral Tilt Right, Lateral Tilt Left, Height Up, and
Height Down .
• Reverse Position cannot
be activated when using the Foot Control.
• Flex, Reflex, Seat Up, Seat Down, and Level cannot
be activated using the
Foot Control.
WARNING
It is strongly recommended that the
DISABLE
button on the
hand control be depressed to switch the hand controller OFF
after table positioning has been completed. This will prevent accidental
activation of a function on the hand control during procedures.
To Next Page
Loading...