Operation
4.3 Messages displayed when espresso machine is ready for operation
Empty the grounds container. Up to five more espressos can be made; after that, the
espresso machine locks.
The temperature of an instantaneous water heater has fallen to more than 10°C below
the programmed value. Please wait until the machine has warmed up again before
dispensing the next product.
Start the cleaning program (cf. 5 "Cleaning", page 5-1).
.....
Container full
.....
Heat up...
.....
clean machine
4.4 Routine operation
Note:
For the functions described in this chapter, it is assumed that the espresso machine is
ready for operation. The display must show the following text:
select beverage
12:00 01.05.2003
Display example
4.4.1 Refilling of espresso beans
Both espresso bean containers (1) should only be filled with max. 1.8 lbs / 0.75 kg of
coffee beans each.
Note:
Never fill the espresso bean containers with a different product than roasted espresso
beans!
The espresso grinder is set for a specific espresso blend. When changing the blend,
the grinder and the dosing apparatus must be readjusted by a manufacturer-
authorized service technician.
Danger!
• Never reach with your hands into the espresso bean container(s) when the
machine is switched on.
• When refilling the bean container(s), do not reach into the grinder and do not
press a product button!
1. Open the lid of the empty bean container.
2. Refill with espresso beans (max. 1.8 lbs / 0.75 kg per container). Replace the
container lid.
4.4.2 Pre-checks
Prior to switching on the machine, check the following:
• The fresh water supply is open
• The espresso bean container(s) is (are) filled (cf.
4.4.1 "Refilling of espresso
beans
” on page 4-3).
• The espresso sliding hatch is open.
• The espresso grounds container has been emptied.
• The espresso machine is connected to the power supply.
• The following text must be shown on the (dark) display:
<<Standby>>
12:00 01.05.2003
Display example
BASO-1 SUSA - 02.04 - V02 Page 4-3
To Next Page
Loading...
