Seite 12
Push blue pushbutton 2 in order to start the automatic operation.
The food product is pushed against the blade by its own weight (gravity).
The carriage is moved automatically
In order to stop the slicing procedure push the yellow pushbutton 1
After having finished the slicing procedure turn thickness knob to zero.
Switch off the machine at the red button main switch off.
Attention! Never try to load the carriage while it is moving automatically. Always switch
off the machine first, otherwise there is a risk to get injured!!
3.7. variable slicing length
The machine is adjusting the slicing length by itself. This is determined by the adjustable bar. The position
oft he adjustable bar is always read out at the first stroke and fixed. Therefore it is necessary that the
carriage is engaged and in the starting position. If the carriage is not in the starting position this process will
not work and the slicing length will not by adjusted according tot he product size. In such a case stop the
carriage by pressing the yellow button 1. Then the carriage will return tot he starting position. Start the
carriage again by pushing the blue button 2. Then the position oft he adjustable bar will be read again and
the cutting length is adapted according tot he product size.
3.8. Slicing of end pieces
Special notes regarding slicing of rests and end pieces of food products:
Before placing the remaining piece of the food product in the carriage you have to cut off the pointed end.
Otherwise the food product cannot be held correctly by the end piece holder. It is even better to turn the
original cutting side of the food product to the end piece holder.
Attention! Risk of getting hurt!
Never try to hold the food product by hand, you may hurt yourself seriously!
Always use the end piece holder.
In case the end piece should clamp or move proceed as follows:
Switch off the machine.
Check if the adjusting bar is fixed.
Lift up the end piece holder
Place the end piece into the carriage as described below
3.9. Slicing end pieces
Pull the carriage backwards for loading the carriage when the
machine is adjusted for manual operation.
Lift up end piece holder
Lay the food product against the back of the carriage.
Adjust the adjusting bar according to the size of the food product.
Place the end piece holder behind the food product.
Adjust the thickness of the slices with the thickness knob.
Choose automatic or manual operation (see 3.4)
Manual operation
Switch on the machine by pushing the green button.
In order to start the blade keep pushing the yellow pushbutton 1 until the
blade starts turning and the upper left LED is illuminated.
The food product is pushed against the blade by its own weight (gravity).
Move the carriage forward and backward by hand
After having finished the slicing procedure turn thickness knob to zero.
By pushing the yellow pushbutton 1 shortly the blade stops
Switch off the machine at the red main switch.
Automatic operation
Switch on the machine by pushing the green button.
To Next Page
Loading...