Seite 8
2. Installation and initial operation
First read the operating instructions very carefully!
You have to pay attention to all notes.
Operating procedures have to be carried out as described.
Always work carefully and with concentration, this way you can avoid damages and injuries. The
installation, introduction and initial operation has to be done by an authorised supplier or service technician.
2.1. Checking the contents of the carton
The supplied carton has to have the following contents:
SCHARFEN food slicer model G 330 A or G 350 A
sharpening device
these operating instructions
2.2. Installation
The food slicer model G330D or G350D has to be installed on a plain, horizontal, non-slip
and stable surface. If necessary the machine has to be screwed tight in addition.
Recommended height of the working surface about 800 mm. Pay attention to the required
counter space.
2.3. Electrical installation
Before you plug in the machine, you have to check if the current supply is the same as indicated on the
rating plate. In case there are discrepancies you have to inform the supplier or technical service.
Under no circumstances plug in the machine!
The socket-outlet has to be equipped with earthing contact. It has to be connected according to customary
regulations.
A defective socket-outlet may damage the machine or endanger the operator.
The socket has to be installed at a place which can be reached easily by the operator, so that in case of
emergency the plug can be pulled out quickly. In any case the socket must not be under the counter or
at a place which cannot be reached easily.
In case it is necessary to exchange the plug, this has to be done by an electrician or the after sales service.
2.4. Checking the direction of blade rotation
Switch on the machine. Push the green push button main
switch on.
Signal lamp is illuminated
The knife will be switched on by pushing the yellow push
button 1 for more then 1 second.
For machines with 3-phase motor:
The blade has to rotate in direction of arrow (counter
clockwise).
In case the blade rotates in wrong
direction, the positions of the poles in
the plug have to be changed by an
electrician or service technician.
3. Operation
3.1. Important notes before switching on the machine
Because of security reasons pay attention to the following notes:
- first read these operating instructions carefully
- take care that the machine is placed on a stable and secure surface
- work with concentration
- never touch the blade
To Next Page
Loading...