Scharfen G330D - Sharpening the Blade; Remove Sharpening Device; 6 Maintenance and Cleaning

Seite 16
5.3. Sharpening the blade
 Switch on the machine
 Turn the hand wheel of the sharpening device in direction 1. By means of this
the sharpening stone sharpening the blade is pushed towards the blade.
 Approximately 15 seconds are enough.
 Switch off the machine
 check if there has been built a visible burr at the edge of the blade
 If not: Sharpen again
 Switch on the machine again
 For taking off the burr turn the hand wheel in direction 2. Now both sharpening
stones are touching the blade.
 Approximately 2 seconds are enough to take off the burr.
 When the sharpening procedure is terminated turn the hand wheel to 0.
5.4. Remove sharpening device
 Switch off the machine.
 Pull the pin of the sharpening device upright in direction of arrow.
 Tilt the sharpening device aside to the right.
 Remove the sharpening device.
Now clean the machine entirely from wheel swarf, see chapter 4. Cleaning. First clean the machine with a
dry cloth. Then make a complete wet cleaning.
Attention! Risk of getting hurt!
Always work with concentration! Do not let distract yourself from your work!
Never check the sharpness of the blade with your fingers.
6. Maintenance and cleaning
machine
warm water,
detergent, acid free
from chlorine
manually
cleaning rag, cleaning
brush
wash up with clear water,
dry
machine with
tefloned parts
warm water,
detergent, acid free
from chlorine
manually
cleaning rag, cleaning
brush
wash up with clear water,
dry
dry tefloned parts very
carefully
detached parts
warm water,
detergent, acid free
from chlorine
manually
cleaning rag, cleaning
brush
wash up with clear water,
dry
blade
warm water,
detergent, acid free
from chlorine
manually
cleaning rag or sponge
wash up with clear water,
dry
sharpening
stones
warm water,
detergent, acid free
from chlorine
manually
cleaning brush
degrease with degreasing
agent (spirit or similar)
Clean the machine at least one time per day.
If necessary sharpen the blade.
The blade has to be exchanged if the gap between blade edge and the fixed protecting ring is more than
5 mm.
If necessary clean or exchange the sharpening stones.
To lubricate the machine, use only lubricants intended for use in
foodstuffs (according to USDA type H1).
Oiling points:
Guiding axle of end piece holder (1 time per week)
Guiding axle of carriage (as required)
0
1
2
15 sec.
< 2 sec.