www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
31
12. Disposal and recycling
The disposal instructions are based on icons placed
on the appliance or its package. A description of the
individual meanings, is shown in chapter “Explana-
tion of symbols on the device”.
Transport package disposal
The package protects the appliance against damage
during transport. Packing materials are usually cho-
sen depending on their environmental friendliness
and disposal method and can therefore be recycled.
Returning the package to material circulation saves
raw materials and reduces waste disposal costs.
Parts of packages (e.g. foils, styropor®) can be dan-
gerous to children. Risk of suffocation! Keep parts of
packages away from children and dispose them as
soon as possible.
13. Troubleshooting
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Problem Cause Remedy
Engine fails to start. • Spark plug wire disconnected.
• Out of fuel or stale fuel.
• Choke not in open position.
• Blocked fuel line.
• Fouled spark plug.
• Engine ooding.
• Attach spark plug wire securely to spark plug.
• Fill with clean, fresh gasoline.
• Throttle must be positioned at choke for a cold start.
• Clean the fuel line.
• Clean, adjust gap, or replace.
• Wait a few minutes to restart, but do not prime.
Engine runs errati-
cally.
• Spark plug wire loose.
• Unit running on CHOKE.
• Blocked fuel line or stale fuel.
• Vent plugged.
• Water or dirt in fuel system.
• Dirty air cleaner.
• Improper carburetor adjustment.
• Connect and tighten spark plug wire.
• Move choke lever to OFF.
• Clean fuel line. Fill tank with clean, fresh gasoline.
• Clear vent.
• Drain fuel tank. Rell with fresh fuel.
• Clean or replace air cleaner.
• Consult the service.
Engine overheats. • Engine oil level low.
• Dirty air cleaner.
• Air ow restricted.
• Carburetor not adjusted properly.
• Fill crankcase with proper oil.
• Clean air cleaner.
• Remove housing and clean.
• Consult the service
Machine does not
move while engine is
running.
• Gear is not properly selected.
• Driving tracks not tight enough.
• Ensure gear lever is not in-between two different
gears.
• Tighten driving tracks.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
