www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
GB
– When processing wood, materials similar to
wood, and plastics. Operation in enclosed
-
11
which it is not meant to be
– Do not use the cable to connect the plug. From
the wall socket. Protect the Protect cables from
heat, oil and sharp edges.
12 Secure the workpiece
– Use the clamping devices or a vice to hold the
workpiece in place. In this manner, it is held
–
workpieces (table, trestle, etc.) in order to pre-
vent the machine from tipping over.
–
the working plate and stop in order to prevent
bouncing and twisting of the workpiece.
13 Avoid abnormal posture
–
– Avoid awkward hand positions in which a sud-
den slip could cause one or both hands to come
into contact with the saw blade.
14
– Keep cutting tools sharp and clean in order to
– Follow the instructions for lubrication and for
tool replacement.
–
specialist when damaged.
–
them when damaged.
–
grease.
15 Pull the plug out of the outlet
– Never remove loose splinters, chips or jammed
wood pieces from the running saw blade.
– During non-use of the electric tool or prior to
maintenance and when replacing tools such as
saw blades, bits, milling heads.
– When the saw blade is blocked due to abnormal
the work piece and ensure that the saw blade
runs free. Turn the machine on and start new
cutting operation with reduced feed force.
16
–
adjusting tools are removed.
17 Avoid inadvertent starting
–
plugging the plug into an outlet.
18 Use extension cables for outdoors
–
extension cables for use outdoors.
–
19 Remain attentive
–
sensible when working. Do not use the electric
20
– Protective devices and other parts must be
free and function as intended prior to continued
use of the electric tool.
– -
-
free operation of the electric tool.
– Damaged protective devices and parts must be
-
– Damaged switches must be replaced at a cus-
tomer service workshop.
–
cables.
–
21 Attention!
– The use of other insertion tools and other ac-
22
electrician
– This electric tool conforms to the applicable
-
parts. Otherwise accidents can occur.
Warning! This electric tool generates an electro-
active or passive medical implants under certain
conditions. In order to prevent the risk of serious or
manufacturer of the medical implant prior to operat-
ing the electric tool.
Additional safety instructions
•
maintenance work on the blade!
•
use a device to stop the workpiece from twisting.
• When cutting boards in upright position, use a de-
vice to prevent kick-back.
• -
-
ensure reliable operation.
•
work on the machine.
•
To Next Page
Loading...
