www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
29
•
-
ter a power failure.
•
check that the voltage marked on the rating plate
•
• Persons working on the machine should not be
distracted.
• Note the direction of rotation of the motor and
blade.
•
put them out of operation.
• Never cut workpieces which are too small to hold
• Never remove loose splinters, chips or jammed
pieces of wood when the saw blade is running.
• It is imperative to observe the accident prevention
• -
al associations.
• Adjustable protective devices have to be adjusted
as close as possible to the workpiece.
• Important! Support long workpieces (e.g. with a
roller table) to prevent them sagging at the end
of a cut.
• Make sure the blade guard (3) is in its lower posi-
tion when the saw is being transported.
• -
use the machine.
•
must not be used.
• If the table insert is worn, replace it.
• Never operate the machine if either the door pro-
are open.
• Ensure that the choice of blade and the selected
speed are suitable for the material to be cut.
• Do not begin cleaning the blade until it has come
to a complete standstill.
• For straight cuts of small workpieces against the
longitudinal limit stop the push stick has to be
used.
• The bandsaw blade guard should be in its lowest
position close to the bench during transport.
• For miter cuts when the table is tilted, the paral-
lel stop must be positioned on the lower part of
the table.
• When cutting round timber, use a suitable holding
device to prevent the workpiece turning.
• Never use guards to lift or transport items.
• Ensure that the bandsaw blade guards are used
•
bandsaw blade. Use a push stick for narrow cuts.
• The push stick has to be stored on the intended de-
vice, so that it can be reached from normal working
• In the normal operating position the operator is in
front of the machine.
• When sawing wood, connect the band saw to a
dust collection device.
•
use a suitable holding device that prevents the
workpiece from twisting.
6. Technical data
Electro motor 220 - 240 V ~, 50 Hz
Power 550 W (S2 20 min)
Revolutions 1400 min
-1
Saw band length 1790 mm
Saw band width 6 mm
Saw band width max. 13 mm
Saw band speed I 660 m/min
Saw band speed II 960 m/min
0 - 120 mm
Opening width 245 mm
Table size 300 x 300 mm
Slewing range of the table 0° - 45°
size of workpiece max. 580 x 400 x 120 mm
Weight 24 kg
The work piece must have a minimum height of 3 mm
and a minimum width of 10 mm.
Operation at constant load for 20 minutes or less, fol-
duration to re-establish machine temperatures within
2 K of the ambient temperature.
The total noise values determined in accordance
with EN 61029.
sound pressure level L
pA
77,4 dB(A)
pA
3 dB
sound power level L
WA
90,4 dB(A)
WA
3 dB
Wear hearing protection.
Total vibration values (vector sum - three directions)
determined in accordance with EN 61029.
To Next Page
Loading...
Need help?
General
