Scheppach HBS261 - Angled Cuts; Making Angled Cuts; Freehand Cuts; Performing Freehand Cuts

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB
|
35
15. Troubleshooting
Problem Possible cause Help
Motor does not work Motor, cable or plug defective, fuses burnt
Housing cover open (limit switch)


-


The motor starts up

operating speed.
Voltage too low, coils damaged, capacitor
burnt
-

a specialist. Arrange for replacement of the

Motor makes excessive
noise
 
specialist
The motor does not reach
its full power.

(lamps, other motors, etc.)

the same circuit
 󰀩-
ing of the motor
Avoid overloading the motor while cutting, re-
move dust from the motor in order to ensure
optimal cooling of the motor
 Saw blade dull, tooth shape not appropriate
for the material thickness
Resharpen saw blade and/or use suitable
saw blade

and/or splinters
Excessive cutting pressure and/or saw
blade not suitable for use
Insert suitable saw blade
Saw blade is not running
straight

Wrong saw blade
Set the saw blade guide according to the
operating instructions
Select a saw blade according to the operat-
ing instructions
Burn marks appear on the
wood during the cutting
work
Blunt saw blade
Wrong saw blade

Select a saw blade according to the operat-
ing instructions
Saw blade jams during
cutting work
Blunt saw blade
Deposits on the saw blade



Set the saw blade guide according to the
operating instructions