Why Scheppach Saw motor starts up slowly?
If the Scheppach Saw motor starts up slowly and doesn't reach operating speed, the voltage might be too low, or the coils could be damaged, or the capacitor burnt. Contact the utility provider to check the voltage and arrange for inspection of the motor and replacement of the capacitor by a specialist.
How to fix rough or wavy saw cut with Scheppach HM140L?
If the Scheppach Saw cut is rough or wavy, it may be because the saw blade is dull or the tooth shape is inappropriate for the material thickness. To fix this, re-sharpen the saw blade and/or use a suitable saw blade.
What to do if Scheppach HM140L motor does not reach its full power?
If your Scheppach Saw motor isn't reaching its full power, the circuits in the network might be overloaded. Try not using other equipment or motors on the same circuit.
How to fix a rough or wavy saw cut with Scheppach Saw?
If the saw cut is rough or wavy when using your Scheppach Saw, the saw blade is likely dull or the tooth shape isn't right for the material. You should re-sharpen the saw blade or use a more suitable one.
Why does my Scheppach Saw motor overheat easily?
If your Scheppach Saw's motor overheats easily, it's likely due to overloading or insufficient cooling. To resolve this, avoid overloading the motor during cuts and ensure you regularly remove dust from the motor to maintain optimal cooling.
How to fix Scheppach HM140L when the motor does not work?
If the motor of your Scheppach Saw does not work, it could be due to a defective motor, cable, or plug, or burnt fuses. Arrange for a specialist to inspect the machine. Check the fuses and replace them if necessary.
Why Scheppach HM140L Saw motor makes excessive noise?
If the Scheppach Saw motor makes excessive noise, it may be due to damaged coils or a defective motor. Arrange for a specialist to inspect the motor.
What to do if Scheppach HM140L Saw motor starts up slowly?
If the Scheppach Saw motor starts up slowly and does not reach operating speed, the voltage may be too low, the coils may be damaged, or the capacitor may be burnt. Contact the utility provider to check the voltage. Arrange for a specialist to inspect the motor and replace the capacitor.
Why workpiece pulls away and/or splinters when using Scheppach Saw?
If the workpiece pulls away or splinters when using the Scheppach Saw, it could be due to excessive cutting pressure or an unsuitable saw blade. Try inserting a more suitable saw blade.
What to do if the Scheppach HM140L Saw motor does not reach its full power?
If the motor of your Scheppach Saw does not reach its full power, it might be because the circuits in the network are overloaded. Avoid using other equipment or motors on the same circuit.
Guidelines for maintaining a safe and organized work environment.
Instructions to prevent electric shock and ensure safe power connections.
Recommendations for personal protective equipment and safe operating practices.
Specific safety precautions for operating mitre saws.
Highlights potential hazards that remain even with proper use.
Detailed instructions for safely replacing the saw blade.
General| Input power | 2000 W |
|---|---|
| Power source | AC |
| AC input voltage | 230 - 240 V |
| AC input frequency | 50 Hz |
| Saw blade included | Yes |
| Number of blade teeth | 48 |
| Idle speed (max) | 7000 RPM |
| Bevel type | Double bevel |
Weight and Dimensions| Depth | 750 mm |
|---|---|
| Width | 590 mm |
| Height | 500 mm |
| Weight | 21030 g |
| Package weight | 25660 g |
To Next Page