www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
25
* Not necessarily included in the scope of delivery!
14.
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
-
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and elec-
tronic equipment (WEEE). This product must be dis-
posed of at a designated collection point.
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper han-
dling of waste equipment may have negative conse-
quences for the environment and human health due
to potentially hazardous substances that are often
contained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
12. Storage
Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
Cover the electrical tool in order to protect it from
dust and moisture. Store the operating manual with
the electrical tool.
13. Maintenance
m ATTENTION!
Pull out the power plug before carrying out any main-
tenance work on the equipment.
• The parts displayed in Figure 7 are the electrode
be replaced once the ceramic cap (15) has been
unscrewed.
• The electrode (18) must be replaced if there is a
crater of approximately 1.5 mm depth in the centre.
• The nozzle (16) must be placed if the central bore
is damaged or if it has expanded in comparison to
a drilling of a new nozzle. If the electrode (18) or the
nozzle (16) are replaced too late, this can result in
an overheating of the parts. This can reduce the lift
Attention!
• The ceramic cap (15) must only be screwed on to
the burner (13) once it has been equipped with the
-
-
ating personnel.
The plasma cutter must be regularly maintained for
perfect function and to comply with the safety require-
ments. Improper and wrong operation may cause
failures and damage to the device. Have repairs only
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Machine data - type plate
Please note that the following parts of this product
-
lowing parts are therefore also required for use as
consumables.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
