Scheppach TIGER 2000S Operating And Safety Instructions

13GB/IE
1. Explanation of the symbols on the device
m
GB IE
Read the operating and safety instructions before start-up and follow them!
GB IE
Read the operating and safety instructions before start-up and follow them!
GB IE
Wear eye protection!
GB IE
Wear hearing protection!
GB IE
Danger of injury due to a rotating tool! Keep your hands away.
GB IE
Keep third-parties away from the danger zone.
ATTENTION!
GB IE
Points in these instructions that concern your safety are marked with this note.
CAUTION!
GB IE
Points in these instructions that concern your safety are marked with this note.
WARNING!
GB IE
A failure to observe these instructions can lead to danger to life or serious injury
Warning! The electrical connection must be established by an electrician and must comply with IEC 364. It is recommended that a residual current circuit
breaker be installed in the electrical connection to this device, which disconnects the mains voltage if the residual current circuit breaker exceeds 10mA
for 30 ms.

Scheppach TIGER 2000S Specifications

General

Grinding Wheel Diameter	200 mm
Grinding Wheel Width	40 mm
Motor Power	120 W
No-Load Speed	120 rpm
Honing Wheel Diameter	200 mm
Honing Wheel Width	30 mm
Grain Size	220