22
3.7 Memory functions
If the memory already contains data, a message will inform you that the data will
be deleted.
fig. 3.7.2.1
You can store and display the statistics of one measuring series (last measured value,
the average, the minimum and maximum measured values, the peaks, the standard
deviation).
3.7.1 Save data
- Press the button to start recording the measured values.
- While recording is in process, “Rec S” flashes on the display.
- Press the button again to stop recording.
- To save the recorded data, press the button (the display shows “Mem”).
Data, stored in the memory before, will be overwritten.
- Press the button to stop recording the measured values without saving
3.7.2 Displaying the saved measured values
- Press the RECALL and buttons simultaneously to display the saved data.
The display will only show statistical values:
- Name of the material to be measured
- Date and time of storage
- Last reading
- Average
- Max.
- Min.
- Standard deviation (Std dev)
- Number of measured values (Records)