SCHOTT Lab 850 - Page 34

Operation Lab 850
34
ba75890e01 11/2009
Switching off the
automatic storing
function
You can terminate the automatic storing function in the following ways:
z set the storage interval (Int.1) to OFF, or
z switch the meter off and then on again.
4 Confirm with <OK>.
Ident, the entry of the ID number is displayed.
5 Set the required ID number with <▲><▼>.
6 Confirm with <OK>.
The meter switches to the measured value display and starts
the measuring and storing procedure.
AutoStore flashes on the display.
7 As soon as all of the 800 memory locations are occupied,
AutoStore is terminated (Int.1 = OFF).
If there are not enough memory locations available for your
measurements:
– Output and backup the data memory (see page 35) and
– clear the memory (see page 36).
1
00
0
Ident