Need help?Do you have a question about the Schrack Seconet Integral MAP and is the answer not in the manual?
Explains symbols used in the document for notes, cautions, and environmental notices.
Describes the five different acoustic modes used by the Integral MAP for alarms and signals.
Explains the function of buttons and LEDs during an alarm event, including fire alarms and delay layers.
Details the display elements and operational buttons within the main control panel interface.
Explains the meaning of various LEDs indicating system status, faults, power, and disablements.
Describes the buttons and LEDs associated with transmission equipment for alarm reporting to external services.
Explains the function of buttons and LEDs controlling acoustic and visual alarm devices (sirens).
Details visual and acoustic indications during a fire alarm and initial response steps.
Explains the activation and deactivation of the delay layer function for managing alarm responses.
Describes how to activate the intervention mode for investigating and managing alarms with delayed outputs.
Explains how to silence or reset active alarm and fault signal tones.
Details procedures for muting or disabling sirens and alarm areas, including authorization levels.
Outlines the process and conditions for resetting an alarm, requiring authorization and problem resolution.
Informs about the transmission system status when location assistance has been contacted and advises on next steps.
Explains how to view and navigate lists of alarms, faults, and other system events.
Details how to interpret and respond to various fault messages, including device and module faults.
Guides on selecting specific elements and querying their current operational states.
Describes how to change authorization levels to access different system functions and operations.
Explains how to perform operations on selected elements, including turning them on/off or resetting functions.
Details how to operate multiple elements of the same type simultaneously using range selection.
Explains how to access the menu to view the count of accumulated alarms.
Explains how to navigate the system menu to access various configuration options.
Details how to view programmed times for automatic switching between operating modes.
Details the procedure for activating or deactivating the log printer function with authorization.
Guides on how to repeat prints of various log lists like event logs, faults, and disablements.
General| Storage Temperature | -20°C to +60°C |
|---|---|
| Networking | Ethernet, RS-485 |
| Redundancy | Optional redundant power supply |
| Power Supply | 24 V DC |
| Standards Compliance | EN 54-2, EN 54-4 |
| Relative Humidity | Up to 95%, non-condensing |
| Protection Class | IP30 |
| Communication Interface | Ethernet, RS-485 |
| Protocol | Modbus, proprietary protocol |
| Type | Modular Fire Alarm Control Panel |
To Next Page
