Schrack Seconet Integral MAP - Operating System Elements

General operations|Operate elements
B-HB-0133EN Operating panel Integral MAP|User manual 23
3. Confirm with the enter button D.
Pressing the button Access Code
K
again you can select whether you want to switch
back to authorisation level 1 or switch to another level. Once the programmed time has
elapsed the system will revert automatically to the authorisation level 1.
5.5 Operate elements
|Operate elements
(An authorisation code must be entered for this to be permitted)
1. Pressing on of the buttons
N
–
Q
selects a list with the individual elements types
(depending on programming and authorisation level).
2. Enter the number of the element to be selected using the numerical buttons of the
keypad
X
.
NOTE
If an individual detector of a detector zone is to be queried, enter the de-
tector number in addition to the detector zone number, separated by a slash
(/).
3. Confirm with the enter button D. If an element has been selected, then the ele-
ment’s current status is shown on the display.
u Pressing the button Off
e
turns the element off.
u Pressing the button On
d
turns the element on.
u Pressing the button Set Reset
f
either sets or resets a function, depending on the
current state.
u Pressing the button Other Commands
g
displays the list of all available com-
mands. Using the scroll buttons E/F to scroll through all the entries in the list. Con-
firm with the enter button D.
NOTE
Using other commands it is possible to disable detectors with time limits.