SCHUNK KHM 40 - User Manual

Questions and Answers

K
Kim CurryAug 12, 2025
Why my SCHUNK Industrial Equipment product does not move?
- W
  Warren MonroeAug 12, 2025
  The SCHUNK Industrial Equipment product might not move due to several reasons. It could be that the pressure drops below the minimum required, so check the air supply. The compressed air lines might be switched, in this case, check compressed air lines. A proximity switch might be defective or set incorrectly, so readjust or change the sensor. Also, unused air connections might be open, so close them. The flow control valve might be closed, so open the flow control valve. Finally, a component part might be defective, so replace the component or send it to SCHUNK for repair.
R
Rachel MillerAug 19, 2025
What to do if piston force decreasing in SCHUNK Industrial Equipment?
- M
  Matthew BrownAug 19, 2025
  If the piston force is decreasing in your SCHUNK Industrial Equipment, it could be due to a few reasons. Compressed air might be escaping, so check the seals and, if necessary, disassemble the product and replace them. Alternatively, there might be too much grease in the mechanical movement space, so clean and lubricate the product. Finally, the pressure might be dropping below the minimum required, so check the air supply.
W
wgibbsAug 27, 2025
Why SCHUNK KHM 40 Industrial Equipment linear unit is not performing the entire stroke?
- M
  Michael SnyderAug 27, 2025
  If the linear unit of your SCHUNK Industrial Equipment isn't performing the entire stroke, it could be because the pressure drops below the minimum, so check the air supply. Another reason might be that the mounting surface is not sufficiently flat, so check the evenness of the mounting surface. Lastly, a component part might be defective, in this case, send the product with a SCHUNK repair order or dismantle the product.
B
Benjamin WigginsSep 2, 2025
How to fix SCHUNK KHM 40 Industrial Equipment lifting unit that opens or closes with a jerk?
- N
  Nathan DuarteSep 2, 2025
  If your SCHUNK Industrial Equipment lifting unit opens or closes with a jerk, it could be due to several factors. There might be too little grease in the mechanical guiding areas, so clean and lubricate the product. The compressed air lines might be blocked, so check them for damage. The mounting surface might not be sufficiently flat, so check the evenness of the mounting surface. Also, a one-way flow control valve might be missing or adjusted incorrectly, so install and adjust it.