Basic safety instructions
10 01.00|ROTA THWplus |en
Danger of limbs being crushed by opening and closing of the
chuck jaws during manual loading and unloading or when re-
placing moving parts.
• Do not reach between the jaws.
• Wear safety gloves.
• Observe the safety and accident prevention regulations during
operation of the chuck, especially in connection with machin-
ing centers and other technical equipment.
Risk of burns due to workpieces with high temperatures.
• Wear protective gloves when removing the workpieces.
• Automatic loading is preferred.
Danger of damage due to incorrectly selected clamping position
of the clamping jaws to the workpiece.
An incorrectly selected clamping position of the clamping jaws to
the workpiece can result in damage to the base and top jaws.
• Make sure that the workpiece clamping is concentric.
• In the case of a chuck with a quick-change jaw system the top
jaws must not protrude radially beyond the base jaws used.
Exception: The supporting jaw variant 3 protrudes beyond the
chuck base jaw due to the construction of the jaw. In this case,
the T-nuts must always be inserted completely into the groove
To Next Page
Loading...
Need help?
General
