Service Manual
Remote Control Cable/Radio
565
use (see operating instructions of truck-mounted
concrete pump).
Turn the receiver off by means of the toggle
switch.
Putting out of Operation
1. Set all controls on the transmitter to “0” or “OFF”
position.
2. Set the selector switch to “OFF”.
3. Press the EMERGENCY OFF button.
4. Switch off the receiver by means of the toggle
switch.
5. **The LED extinguishes.
6. Switch the truck engine off and remove the
“ignition key”.
7. Lock the transmitter in the driver’s cabin and
secure the machine against unauthorized use.
Changeover to Cable Remote Control
1. Put out of operation as described above.
2. Remove the connecting cable: between receiver
and control panel from machine control panel.
3. Connect standard remote control cable to the
machine control panel.
4. Perform commissioning as normal for cable
remote control.
5
4
3
2
1
8
9
14
13
12
10
11
4
3
2
1
To Next Page
Loading...