Service Manual
Remote Control Cable/Radio
595
17. Repair
For repairs or for regular checks, the receiver must be
removed from the vehicle and sent to the factory for
repair complete with the transmitter.
For repairs outside Germany, please address to your
local agent.
Take care that the equipment is packed shock-proof.
REMOVAL OF RECEIVER
• Push EMERGENCY SHUT-OFF button.
• Open cover, as described in section 16
• Withdraw the (blue) multipole connector from
the circuit board.
• Pull off the antenna cable.
• Loosen the four fastening screws at the front
side.
Depress the screws slightly and turn counter-clockwise
by 90 degrees without further turning.
Withdraw the receiver unit carefully an d smoothly
from its compartment in the vehicle.
INSTALLATION OF THE RECEIVER
• Push EMERGENCY SHUT-OFF button.
• Insert receiver carefully and smoothly into its
compartment.
• Turn the fastening screws clockwise by 90
degrees, and engage under slight pressure without
further turning.
• Plug in antenna and multipole connector.
• Close the cover.
To Next Page
Loading...