Service Manual
Remote Control Cable/Radio
598
Safety Instructions
SAFETY INSTRUCTIONS
Please read these operating instructions
completely before putting your
TELETEC
remote-control into operation.
Observe also the corresponding working
safety and accident prevention regulations.
The instructions relating to the operation of
the machine itself are contained in the
machine manual.
Remote-control units may be used by duly
authorized persons after they have been
instructed by a specialist.
Do not put the operational transmitter aside,
but always protect it against unauthorized
use by locking it away.
The remote-control may only be used for
purposes complying with its designated use
i.e. only for controlling the machine or plant
for which it is designated.
Any other use is forbidden.
Using the device for purposes other than its
designated use, faulty operation, insufficient
maintenance and unauthorized repairs of
the remote-control unit may cause severe
material damage and injury to persons.
In the event of malfunction or defects of the
remote-control unit depress immediately the
red EMERGENCY SHUT-OFF button,
switch the transmitter off and keep it in a
safe place.
Disconnect all cables from the receiver if
your remote-control is a "MULTI-Control"
unit.
If your remote-control is a "COMFORT-
Control" unit, the radio receiver must not be
disconnected. Cable operation may
otherwise be impossible.
Repair work on the remote-control unit may
only be performed by
TELETEC
or by
qualified personnel duly authorized by
TELETEC
.
Non-observance of the safety instructions
will discharge
TELETEC
from any and all of
their warranty and liability obligations.
To Next Page
Loading...