Service Manual
Remote Control Cable/Radio
580
10. Pre-Operational Instructions
• Position the vehicle as described in the
machine operating instructions.
• Set all control elements of the cable control
unit (if connected) and the control elements of the
machine to “0” position.
• Shut off drive engine when it is warm. Remote
control cannot be used to activate any existing
cold-starting aid. Leave the ignition on.
• If required, remove the cable control unit con-
nector and insert the radio receiver connector into
the socket outlet.
• During “cable-controlled” operation, the radio
receiver connector is in the unwired socket.
• Lock the cable-connector.
• Set selector switch on the machine to
“REMOTE”.
• Release all EMERGENCY SHUT-OFF but-
tons of the machine (cf. machine operating instruc-
tions).
• Switch on receiver power supply with key
switch in the driver’s cab.
• The ON state is indicated by lamps on the
receiver.
To Next Page
Loading...