28
17. Final Inspection
Inspect your machine to ensure that all fasteners are tight and components are properly assembled.
Be sure to record the serial number in the eld provided at the front of this manual.
Carefully remove the protective plastic film from the display screen, keypad and top of the Console. Due to static electricity,
“ghost” images may show on the screen but these will disappear after a few minutes.
Apply a small amount of silicone lubricant to a cloth and wipe the Rails to eliminate roller noise.
Silicone lubricant is not intended for human consumption. Keep out of reach of children.
Store in a safe place.
Do not use until the machine has been fully assembled and inspected for correct
performance in accordance with the Owner’s Manual.
14
3
2
4
7
8
4
9
3
5
10
11
12
13
1
6
15
16
*
*
*
*
17
NOTICE: After your rst few workouts, some
hardware will need to be tightened
again. To ensure quiet and smooth
operation, make sure to tighten
the indicated hardware after three
workouts.
Be sure to inspect and fully tighten
all hardware monthly or after every
20 hours of use.
Console Mast
Rail Assembly
Incline (Lift) Motor
Arm
Rail Assembly
To Next Page
Loading...
