EasyManua.ls Logo

Schwinn AD6 - SPECIFICATIONS; Pre-Assembly Area Setup; Assembly Process Tips

Schwinn AD6
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Machine Weight:
Power Requirements:
Operating Voltage:
Maximum User Weight:
115 Ibs. (52.2 kg)
2 AA Batteries
(not included)
1.0 - 3.3VDC
300 Ibs. (136 kg)
Regulatory Approvals:
(( Ro
S
This product conforms to the applicable EN ISO 20957 international Standards for Stationary Training Equipment, Class S
DO NOT dispose of this product as refuse. This product is to be recycled. For information on the proper method of
disposal, contact a Nautilus Customer Service Representative. Contact information is available in the Contacts
section in this manual.
This product, its packaging, and components contain chemicals known to the State of California to cause cancer,
birth defects, or reproductive harm. This Notice is provided in accordance with California's Proposition 65. If you
would like additional information, please refer to our website at www.nautilus.com/prop65.
Before Assembly
Select the area where you are going to set up and operate your machine. For safe operation, the location must be on a
hard, level surface. Allow a workout area of a minimum 73.7" (187.2 cm) x 97.7" (248.2 cm).
Basic Assembly Tips
Follow these basic points when you assemble your machine:
Read and understand the "important Safety instructions" before assembly.
Collect all the pieces necessary for each assembly step.
Using the recommended wrenches, turn the bolts and nuts to the right (clockwise) to tighten, and the left (counterclock-
wise) to loosen, unless instructed otherwise.
When attaching 2 pieces, lightly lift and look through the bolt holes to help insert the bolt through the holes.
The assembly requires 2 people.

Other manuals for Schwinn AD6

Related product manuals