SCIWIL M58-LCD - Error Code; Serial Code

-
12
-
Changzhou Sciwil E-Mobility Technology Co., Ltd.
9
th
Huashan Road, Changzhou, Jiangsu, China- 213022
Fax: +86 519-85602675 Tel: +86 519-85600675
Number for Speed Gauge, Speed Limit, Direct Start and Kick-to-Start, Drive
Mode, PAS Sensitivity, PAS Start Strength, Disc Type of PAS Sensor, Current
Limit of Controller, ODO Range Clearance, etc.
In the Setting Menu, press the Up Key or Down Key to set the value for
the current item. The corresponding item will blink after setting, then press
the M Key to save the set value and switch to the next item. Press and hold
both the Up Key and Down Key to exit settings. Without any operation, the
system will automatically save the set value and exit the Setting Menu.
1.3.7 Error Code
Error Code Table
Error Code (decimal)
Status
Note
E00
Normal
E03
Brake Engaged
E05
Throttle Failure
E06
Low Voltage Protection
E07
Over Voltage Protection
E08
Motor Hall Signal Error
E09
Motor Phase Error
E16
Controller Error
E23
Front Light Error
E27
Controller Over Current Error
E30
Communications Error
2. Serial Code
Each Sciwil display product bears a unique Serial Code on the back shell, (as
shown in the photo below)：192 2 1 210603011