Pag. 18-EN UMT/WG T MT Rev3.0 – 08/10/2021
8.3 Regulation set point
Select “Compressor” and press “Enter”
Select “Regulation” and press “Enter
If there are no serial communication between the
CDU and the remote evaporators, compressor will
be managed with a fixed setpoint.
Suction set point request.
In case of remote evaporators enabled, regulation
type switch automatically from fixed point to
floating setpoint
Min. and max. setpoint variation admitted.
The above values are the factory settings. They can require some adjustments
according to the system response.
The factory settings doesn’t include the evaporator management.
With the standard factory setting the unit will work based on a fixed suction set-point.
To Next Page
Loading...
