C2648 Prodigy and Prodigy Plus Service Manual
January 2015
Page 58
Repair Procedures
1. Inlet Water Solenoid Valve
2. Disconnect electrical power
3. Shut off the water supply.
4. Remove front panel.
5. Unplug wire from coil.
6. Disconnect water supply tube from the inlet of the valve.
7. Disconnect the water outlet tube.
8. Remove the two mounting screws holding the valve to the center panel.
9. Pull the valve forward and out of the machine.
10. Reverse to reassemble.
Electrical Shock Hazard
Disconnect electrical
power before beginning
To Next Page
Loading...
