Light control
Low / High beam
By means of (A) it is possible to switch from
low beam to high beam and vice versa: position (B)
for high beam, position (C) for low beam. To flash,
press the (D).
If engine is not turning the key to on, it
is possible to switch on the lights or
flash.
If within 60 seconds from the manual switching on of
the low or high beam the engine is not the
lights are turned
To preserve the motorcycle the headlight is
automatically switched when the engine
and it is then switched on again when the engine has
DRL in "Auto" mode – only for version with
DRL lights
If the DRL was set to "Auto" via the "DRL" function
within menu” (see page 137), the
instrument panel automatically manages the DRL
and the low beam according to detected ambient
light:
Fig 37
Fig 38
61
To Next Page
Loading...