9 Packet-Radio
131
Persistence on port 1 set to 32:
pac: PE 1:32 <Return>
9.8.28 PRBox
Default setting: 1
Parameter: 0 PR mailbox switched off.
1 PR mailbox switched on.
2 PR mailbox, only private messages
Enables the PR-mailbox to be switched on or off, or the mailbox to be configured as a
maildrop. (Maildrop means that only data addressed to the PTC MYCALL will be
accepted by the mailbox. This is a legal requirement in many countries, as an open BBS
may only be operated by especially licensed stations). The function is similar to the Box
command of the PACTOR level (cmd:-prompt). The Box command relates to
PACTOR/AMTOR only. The PRBox command to Packet-Radio only.
9.8.29 Quit
Exits the Packet mode. Returns to the cmd: input prompt.
9.8.30 RESptime
Default setting: 500
Parameter: X 1... 30,000, response time delay
Sets the value for the AX.25 timer-2 (T2) in milliseconds.
After receiving a packet the PTC-IIIusb waits the time T2 to check if another packets
follow. If so, all packets can be confirmed with only one control packet.
9.8.31 REtry
Default setting: 10
Parameter: X 0... 255, number of repeats.
REtry sets the maximum number of repeats, and, if this value is exceeded, then the
PTC-IIIusb gives out the message:
LINK FAILURE with <call>
9.8.32 Setchn
Default setting: 1
Parameter: X 0... 31, channel.
Switches between the various channels.
To Next Page
Loading...
