6 Commands
64
American controllers, <CR><CR><LF> no longer causes an unwanted empty line. A
number of commercial RTTY services (e.g. Meteo services) also still use the historical
double-CR at the end of every line. These services can be better copied when LF=2.
6.46 LICENSE
Default setting: none
The License command does not accept any argument, as PACTOR-3 is always enabled
by default with the PTC-IIIusb. If License is sent to the unit, it always responds with a
dummy string just like:
LICENSE: 010000141714CB53 ABCDEFGHIJKL
With this, the PTC-IIIusb always appears as PACTOR-3 licensed to any accessing
application software on the PC.
6.47 LIN
Default setting: 128
Parameter: X 20... 128, Number of characters before an auto linefeed.
Auto linefeed after X transmitted characters (word wrap). The auto linefeed is turned off
with the value 128.
6.48 LIst
Remote
Lists the contents of a directory in the PTC mailbox.
The short-form L for the LIst command is also accepted by the remote station, as in
this case no possible confusion with Listen can occur!
The output format is valid also for the DIR command (refer to chapter 6.36, page 60)
Examples:
L DK5FH Lists all messages for DK5FH.
L DK5FH 4 Lists the message no 4 for DK5FH.
L DK5FH 4- Lists from message no 4 onwards for DK5FH.
L DK5FH 3-5 Lists messages 3 to 5 for DK5FH.
L ALL Lists all messages in the directory ALL.
L ALL 4-5 Lists the messages 4 to 5 in the directory ALL.
L 5 Lists message no 5 in the current directory.
L List all messages in the current directory.
To Next Page
