6 Commands
79
6.80 REMote
Default setting: 1
Parameter: 0 Remote control disabled.
1 Remote control enabled.
2 Remote control enabled to the TRX command set.
This command permits the access to the remotable control commands for a distant station.
With REMote 1 the remote commands are enabled. The other station can now use all the
commands signified with Remote . All these commands must, however, have the remote
control characters // prefixing the commands (e.g. //Write test or //Dir).
The remote sequence "//" must be placed at the beginning of a new line, to be valid.
The REMote command should be set to 0 for 7plus transmission.
Also, directly after a connect, or CHANGEOVER to receive, the PTC-IIIusb is internally
at the beginning of a new line, and thus processes the directly following // sequence as a
remote control sequence, this limitation of only being accepted at the beginning of a new
line increases the data transparency quite considerably.
Multiple remote control commands are allowed. Each command must end with a <CR>.
A single command does not need the <CR> to end it, if a CHO character immediately
follows the command. System messages of the remote controlled PTC are transmitted in
lower case, as this gives better Huffman compression, and a clearer display.
REMote 2 additionally enables the full transceiver-control command set. All TRX
commands as TRX <TRX command> at BOX=1 or //TRX <TRX command> at BOX=0 is
available. The user has the chance to receive the frequency list of the PTC-IIIusb,
including the capability of changing the transmit frequency or modifying the channel list
(e.g.
'TRX S 0' or '//TRX S 0' stops the scan function) with the command //TRX L or //TRX C.
The Remote control access may be blocked with REMote 0.
6.81 RESEt
Remote
Soft reset of the System!
This command may be used at any time and causes an uncontrolled disconnect while
connected! The parameters entered and the PTC mailbox, as well as the log, are not
deleted.
6.82 RESTart
Causes a complete re-initialization of the PTC to factory defaults
This command may be used at any time and causes an uncontrolled disconnect while
connected! Customized parameters are replaced by the defaults from the ROM, and the
mailbox messages, as well as the log, are erased.
To Next Page
