SCS PTC-IIIusb - Activating the Bootloader; Bootloader Commands; Fcall; Fselcall

14 The Bootloader
180
14.2 Activating the Bootloader
The Bootloader is activated with the “BIOS” labeled switch on the rear side of the unit. If
the PTC-IIIusb is in Bootloader mode then only the CON-LED lits.
14.3 Bootloader commands
14.3.1 FCall
Default setting: none
Parameter: CALL Flash call, max. 8 characters.
Checking and setting of the flash call. By using the FCall command, it is possible to
store your own callsign permanently in FLASH ROM.
Stores the flash call DL3FCJ
cmd: FC DL3FCJ <Return>
Checking the flash call.
cmd: FC <Return>
The flash call is used as default callsign by the PACTOR firmware after a RESTart.
14.3.2 FSelcall
Default setting:
none
Parameter: SELCALL Flash-Selcall, max. 4 characters
Checking and setting of the flash selcall. By using the FSelcall command, it is
possible to store your own selcall permanently in FLASH ROM.
Stores the flash selcall DFCJ
cmd: FS DFCJ <Return>
Checking the flash selcall.
cmd: FS <Return>
The flash selcall is used as default selcall by the PACTOR firmware after a RESTart.
14.3.3 Help
Displays all useable commands. It is also possible to obtain further help on a command
whilst in Bootloader mode with Help <CMD>.
More details to the SERbaud command
cmd: Help SERBaud <Return>
or shortened to:
cmd: H SERB <Return>