r3bEL mini User Manual
41
8 Shutdown Procedure
1. Click the Disconnect button on Pronterface, then exit the application.
2. Unplug the microUSB cable from your computer.
3. Turn off the bioprinter.
EMERGENCY SHUTDOWN: In the event of an emergency, use the power switch on the back of
the bioprinter. Turn off the bioprinter immediately for any of the following reasons:
● Extruder is repeatedly ramming into sides of printer
● Extruding excessive amount of liquid
● Extruding or retracting past the limits of the extrusion unit
● Extrusion unit is moving past its limits (hitting sides of printer)
● Heater malfunction (too hot, burnt smell, etc.)
● Wiring malfunction (short circuit, burnt smell, etc.)
● Any other situation that could harm the printer or user
Warning: When you turn off the power to the printer, the bed will drop down immediately.
To Next Page
Loading...