r3bEL mini User Manual
50
recommend that you consult one of our technical staff who can
provide recommendations and help you through the process.
Printing issue related to
droplets
For printing issues related to droplet not forming or 2 droplets
being released as one time, please reference the G-code
Adjustment section above.
Be sure to have manually “primed” the syringe. For instructions
on how to do this, see step 3 on page 23.
Attempting to extrude with
no tool selected
This usually happens when you stop mid-print. Type T0 in the
command bar and send it.
Macro file homeall.g not
found.
This usually happened when the SD card in the board is little loose
or is not recognized properly. To fix this issue:
1. Turn off the printer
2. Disconnect the printer in Pronterface/ Web control
3. Unplug the USB cable from the computer
4. Take the SD card out from the slot in the board and put it
back in.
5. Plug USB cable back into computer
6. Open Pronterface/ Web control application
7. Connect to printer
A detailed list of general printer issues and troubleshooting techniques for our specific controller
board (Duet board) has been compiled by RepRapPro and is available at:
https://reprappro.com/documentation/troubleshooting-introduction/
12 Technical support
For more technical support or issues, please email us at support@SE3D.com
To Next Page