1. Connect the Ethernet cable to the NAS Pro and the router.
2. Connect the power cable to the NAS Pro and the outlet.
You can also connect:
A second Ethernet cable for redundancy or performance.
Step 2 – Power on the NAS
When first booting a diskless Seagate NAS Pro, the device must be placed into recovery mode. To enter
recovery mode, make certain to:
Push the recovery button as instructed below.
Continue to push the recovery button while applying a short push on the power button. See Operation for
Cable management: Careful management of cables is recommended for optimal operation. It
prevents potential hazards and allows for easier maintenance.
To Next Page
Loading...
