24
Epoxy.
Epoxy.
C/A glue.
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the fuse-
lage using a felt-tipped pen.
.
.
C/A glue
APPLY THE DECALS.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean and
free from oily ngerprints and dust. Position
decal on the model where desired, using the
photos on the box and aid in their location.
2) If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be c ertain the
model is clean and free from oily ngerprints
and dust. Position decal on the model where
desired, using the photos on the box and aid
in their location.
INSTALLING THE BATTERY-
RECEIVER.
1) Plug the ve servo leads and the switch
lead into the receiver. Plug the battery pack
lead into the switch also.
2) Wrap the receiver and battery pack in the
protective foam rubber to protect them from
vibration.
3) Route the antenna in the antenna tube in-
side the fuselage and secure it to the bottom
of fuselage using a plastic tape.
Receiver.
Battery.
M4x15 mm
To Next Page
Loading...
