Process: Plexus PC- 120 Application Instructions
Remember these points! To avoid problems with Plexus PC-120:
• Don’t use too much PC-120. Only a thin layer is needed.
• Use a clean rag to wipe PC-120 off before it completely dries to remove surface contaminants it
has cleaned. Good quality paper towels are a better choice to minimize introduction of
contaminates to surface.
• Any sign of corrosion already on the surface should be removed by abrading BEFORE priming.
• Check the lot number for the date to make sure the PC-120 is less than a year old.
Questions
• Please contact Plexus Technical Service at 1-800-851-6692 or info@itwplexus.com
To Next Page
Loading...
