SEAL 62C - Material Specifications; Machine Specifications

Specifications 15
English
3.3 Material specifications
Maximum width: Metric American
Process up to 50°C (122 °F) 1575 mm 62 in.
Process up to 125°C (257 °F) 1524 mm 60 in.
Maximum roll diameter:
Material unwind 305 mm 1 ft.
Release liner wind-up (upper wind-up) 180 mm 6 in.
Release liner wind-up (lower wind-up) 200 mm 8 in.
Maximum panel thickness: 38 mm 1.5 in.
Roll core inside diameter: 76.2 mm 3 in.
3.4 Machine specifications
Power supply requirements:
62C 1N/PE 230VAC +/- 10%, 50/60Hz, 2A
62S 3N/PE 230VAC +/- 10%, 50/60Hz, 16A
For the correct supply voltage version refer to the identification label on the machine.
Standard number of shaft positions:
Material unwind 1 (auto-grip)
Release liner wind-up 1 (auto-grip)
Unwind/wind-up 2 (auto-grip)
Optional features:
Extra plot unwind for 2” and 3” cores (customer installable)
Easy Feed in-feed table (factory installed)
Nip setting: 0–40 mm 0–1
9
/
16
in.
Pressure: 1–2.5 N/mm 5.71–14.28 lbf/in.
Process speed:
Maximum 6 m/min 20 ft/min
Slow mode 0.6 m/min 2 ft/min
Maximum roller temperature:
62S 140 °C 284 °F
Noise level <70 dB(A)