42 User Manual 62C/62S
Material rolls are jumping.
A regular tick can be heard in the shaft support.
• Adjust the shaft support (1) by turning up or down the screw with an Allenkey (2).
Figure 27: Shaft support adjustment.
6.4 Technical assistance
For technical assistance you can contact your dealer or the address on the copyright page
in the front of this manual.
Make a clear description of the problem before contacting technical assistance.
Please keep the type and serial number of your machine at hand.
You can find this data on the identification plate of your machine, which can be found on
the rear side of the right cabinet.
To Next Page
Loading...
